info@prolianceuae.com +971 4 2674 920

STEGO- Distributors of Stego in Uae

Small, Compact Thermostat KTO 011 / KTS 011

KTO 011: Thermostat (normally closed); contact breaker for regulating heaters
.
KTS 011: Thermostat (normally open); contact maker for regulating of filter fans and heat exchangers or for switching signal devised when temperature limit has been exceeded.

Features

  • Large setting range
  • Small size
  • Simple to mount
  • High switching performance

Mechanical Hygrostat MFR012

The Electromechanica thermostat MFR 012 is designed to control enclosure heaters so that the dew point is raised when a critical relative humidity of 65% is exceeded. In this way condensation and corrosion is effectively prevented,

Features
  • Adjustable relative humidity
  • Change-over contact
  • High switching capacity
  • Easily accessible terminals
  • Clip fixing

RFP 018 Roof Filter Fan 177-338 CFM

Roof filter fans and roof exhaust filters are used in enclosures from which warm air must be diverted due to increased heat development. The ready-to-connect and low-noise roof filter fan is used to expel warm air from within the enclosure. Alternatively, the roof exhaust filter provides passive ventilation. The RFP 018 series comes in two versions, one utilizes four small axial fans, improving reliability and maintaining continous operations even if one of the fans should fail, the second uses a larger single high capacity fan.

Features
  • Very low noise
  • Minimal mounting depth
  • High air volume
  • High reliability
  • Time-saving installation

Small Semiconductor Heater HGK 047 Series 10W to 30W

The heaters are used in enclosures where condensation is to be prevented or the temperature may not fall below a minimum value. In this way corrosion is avoided and an even temperature is ensured.

Features

  • Dynamic heating up
  • Energy saving
  • Wide voltage range
  • Temperature limiting
  • Clip Fixing

Filter Fan FF 018 Series 21m3/h - 102m3/h

Filter fans are used to provide an optimum climate in enclosures. The interior temperature of an enclosure can be reduced by channelling cooler filtered outside air into the enclosure thus expelling heated internal air. The resulting air flow prevents formation of localised hot pockets and protects the electronic components from overheating.
.
Features

  • Very low noise
  • Minimal depth in enclosure
  • Functional design
  • Time-saving installation

Semiconductor Heater HG 140 series 15W to 150W

These heaters are used in enclosures where damage from condensation must be prevented,or where the temperature may not fall below a minimum value. The aluminium profile heater body design has a chimney effect and distributes the heat evenly, The pressure clamp connectors save time and simplify installation.
.
Features

  • Pressure clamp connectors
  • Dynamic heating up
  • Wide voltage range
  • Temperature limiting
  • Energy saving
  • Clip fixing
  • Quick installation

Our Products

Our Divisions